Filter
Top Products
Making Settings for the M-48
22
In addition to setting the source level, pan, and source assign settings, the mixing engineer can also make the following settings.
* For details on how to make these settings, refer to the owner’s manual of the M-400 (Ver. 2.0 or later) or the S-4000 RCS Ver. 2.0.
In order to manage multiple M-48 units, a unit name (up to eight
alphanumeric characters) can be assigned to each M-48 unit.
●
Solo setting
Solo mode setting
This specifies the solo mode.
Operation when switching layers
When the group layer is switched, you can specify whether Solo will
automatically be defeated for the layer that is no longer shown.
●
[MEMORY] button setting
You can specify whether to disable the M-48’s [STORE] button or
[RECALL] button.
●
Line out setting
Source selection
This selects the line out source.
Low pass filter setting
This allows you to specify that only the low frequencies will be output
from your floor monitor.
MONO switch setting
If this is on, a monaural mix will be output.
NO NAME
●
SOLO
●
MEMORY
●
LINE OUT
Other settings
(settings made by the mixing engineer)
Unit name assignment
Preference settings
Mode
Operation
ADD ON
Multiple groups can be selected. The selected
groups will be mixed for monitoring.
LAST Only the last-selected group will be monitored.
Preference settings
(continued)
Setting Operation
MAIN BUS
The MAIN bus will be monitored.
AUX BUS
The signals mixed to the AUX bus by the AUX
switches of the source level/pan settings (p. 21)
will be monitored.
PHONES
Headphone output (before PHONES LEVEL) will
be monitored.
Setting
Operation
OFF
The low pass filter will not be used.
80Hz The frequencies below 80 Hz will be passed.
120Hz The frequencies below 120 Hz will be passed.
Default Values of the Settings
Source level/pan settings
Source
Level Pan AUX switch
Source 1–16
0.0 dB
C (center) ON
Course 17–40 -Inf dB
Source assign settings
Group
Assigned source Group Assigned source
Group 1
Source 1 Group 9 Source 9
Group 2 Source 2 Group 10 Source 10
Group 3 Source 3 Group 11 Source 11
Group 4 Source 4 Group 12 Source 13
Group 5 Source 5 Group 13 Source 13
Group 6 Source 6 Group 14 Source 14
Group 7 Source 7 Group 15 Source 15
Group 8 Source 8 Group 16 Source 16
Group mix
Group Volume Pan Reverb send High gain Mid gain Mid frequency Low gain Solo
Group 1–16 0.0 dB C (center) -Inf dB 0.0 dB 0.0 dB 1.00 kHz 0.0 dB Off
Unit name
Preference settings
MODE
ADD ON
LAYER select clears SOLO
No
Disable RECALL button
No
Disable STORE button
No
SOURCE
MAIN BUS
LPF (Low pass filter)
OFF
MONO
OFF
M-48_e.book 22 ページ ２００９年２月２４日 火曜日 午前９時３３分