Filter
Top Products
Connecting External Devices
17
* The S-1608 system must be running system software version 2.0 or later.
If you’re using the S-4000 system, the S-4000 system must be running system software 2.1 or later.
* In order to maintain the transmission quality of the digital REAC signal, use fully approved Cat5e Ethernet cable such as the 20 meter or 100 meter REAC
cables (SC-W20F/SC-W100S/W100S-R; sold separately).
Connecting the M-48 to an Analog Mixer System
S-4000D
S-1608 (Master REAC device)
Computer
Analog/Digital Mixer
REAC port 1 or 2
M-48 x 8
Vocal 1 Vocal 2 Vocal 3 Keyboard Guitar BassLead Vocal Drum
Serial port
4
5
6
7
8
910
REMOTE
connector
RS-232C cable
REAC port
INPUT connector 1–16
REAC cable or Cat5e Ethernet cable
REAC port 3
REAC cable or Cat5e Ethernet cable
* You’ll need to install the S-4000 RCS
version 2.0 S-4000 remote control
software.
* You can connect up to 16 bus out or channel
direct out signals.
If the S-1608 is replaced by the S-4000S, a
total of 40 signals can be connected.
M-48_e.book 17 ページ ２００９年２月２４日 火曜日 午前９時３３分