Roland M-48 DJ Equipment User Manual


 
Using the Memory Functions
31
Here’s how to recall mixer settings into current memory.
* You cannot execute this operation if the [RECALL] button has been
disabled in the preference settings (p. 22).
1
Press the [RECALL] button.
The [RECALL] button will light, and Recall mode will be on.
At the same time, all [SOLO] buttons will start blinking. The [SOLO]
button of the current memory number will be lit.
* Recall mode will turn off if you press the [RECALL] button once
again.
* The [1-8] or [9-16] button will blink to indicate the range of
memory numbers shown.
2
Press the [1-8] or [9-16] button to select the desired range
of memory numbers.
3
Press the [SOLO] button of the memory number that you
want to recall.
The [RECALL] button and the [SOLO] button you selected as the
target of the recall will blink.
4
Press the [RECALL] button to execute the Recall
operation.
You can also execute the Recall operation by pressing the blinking
[SOLO] button.
When the recall has been completed, the [RECALL] button will go out
and Recall mode will turn off.
* If you decide to cancel without recalling, press any button that’s
not blinking.
Here’s how to return all data in the M-48 to the factory-set
condition (Factory Reset).
* If the M-48 contains important data, perform the appropriate
operations on the M-400 or computer to save the M-48’s settings to
USB memory or to your computer before you perform the factory
reset.
For details on how to save data, refer to the owner’s manual of the
M-400 (Ver. 2.0 or later) or the S-4000 RCS Ver. 2.0.
1
Turn on the power (Connect the Cat5e cable) while
holding down the [STORE] button and the group 1 [SOLO]
button
(p. 20)
.
The factory reset will be executed. When it is completed, all
indicators of the top panel will blink.
The factory reset will require approximately 30 seconds.
2
Turn off the power
(p. 20)
.
Recalling Mixer Settings from Memory
(Recall)
Button
Range of memory numbers
[1-8] button
1–8
[9-16] button 9–16
Returning to the Factory Settings
(Factory Reset)
M-48_e.book 31 ページ 2009年2月24日 火曜日 午前9時33分