Filter
Top Products
30
Using the Memory Functions
The current mixer settings are held in “current memory.”
Current memory contains the following settings.
•
Source level/pan settings
•
Source assignment settings
•
Group mix
(volume, pan, reverb send, EQ, and solo for each group)
•
Reverb on/off
The M-48 provides 16 memory locations to which the current
memory can be stored and from which a desired memory can be
recalled.
The most-recently stored or recalled memory number is called
the “current memory number.”
Store/recall operations can be performed from the M-48 itself,
the M-400, or a computer.
* With the factory settings, memory locations 1–16 contains the default
mixer settings.
Here’s how to store the current memory.
* You cannot execute this operation if the [STORE] button has been
disabled in the preference settings (p. 22).
1
Press the [STORE] button.
The [STORE] button will light, and Store mode will be on.
At the same time, all [SOLO] buttons will start blinking. The [SOLO]
button of the current memory number will be lit.
* Store mode will turn off if you press the [STORE] button once
again.
* The [1-8] or [9-16] button will blink to indicate the range of
memory numbers shown.
2
Press the [1-8] or [9-16] button to select the desired range
of memory numbers.
3
Press the [SOLO] button of the memory number into
which you want to store the current settings.
The [STORE] button and the [SOLO] button you selected as the
storage destination will blink.
4
Press the [STORE] button to execute the Store operation.
You can also execute the Store operation by pressing the blinking
[SOLO] button.
When the Store operation has been completed, the [STORE] button
will go out and Store mode will turn off.
* If you decide to cancel without storing, press any button that’s not
blinking.
* Storing will take approximately two seconds. During this time, the
M-48 will not be operable.
About Memory
Memory 1
Memory 2
Memory 3
Memory 16
Current memory
number
:
:
:
:
Store
Recall
Current memory
(the current mixer settings)
Memory number
The current memory is backed up to the M-48’s internal flash
memory approximately every 30 seconds. The next time the M-48 is
started up, the backed up settings will be reproduced.
If you want to immediately back up the current memory, perform
the following step.
1 Hold down the [STORE] button for approximately two
seconds.
The current memory will be backed up.
* This operation does not provide storage to memory numbers
1–16. If you want to carry out storage, proceed as described
in “Storing Mixer Settings to Memory” on this page.
Backing up the current memory
Storing Mixer Settings to Memory
(Store)
Button
Range of memory numbers
[1-8] button
1–8
[9-16] button 9–16
M-48_e.book 30 ページ ２００９年２月２４日 火曜日 午前９時３３分