Filter
Top Products
19
Before You Start Playing
NOTE
Using undue force to open the lid when it is locked may
damage the lid and/or the lock.
Turning the lid lock when the lid lock is released while
the keyboard lid is open may make the keyboard lid
prone to closing. Always confirm that the keyboard lid is
covering the control panel before locking the lid.
Connecting the Pedal Cord
1.
Connect the pedal cord to the Pedal jack located in the
jack panel on the lower left of the RG-7.
fig.00-01
Connecting the Power Cord
1.
Connect the supplied power cord to the AC inlet.
2.
Connect the pedal cord to the Pedal connector.
3.
Cramp the power cord and pedal cord with Cord
Cramp and screw at A, B, and C (see the picture
above).
4.
Plug the power cord into an AC outlet.
Turning the Power On and
Off
NOTE
Turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you
risk causing malfunction and/or damage to speakers
and other devices.
To turn the power on, turn the [Volume] knob all the
way down, and then press the [Power] switch.
When you turn on the power to the RG-7, the front panel
display appears as shown below.
After a few seconds, you will be able to play the
keyboard to produce sound.
Use the [Volume] knob to adjust the volume.
NOTE
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
To turn the power off, turn the [Volume] knob all the
way to the left, and press the [Power] switch.
The front panel display goes blank, and the power is
turned off.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply” (p. 6).
b
a
a
b
Screw
Cord Cramp
RG-7_e.book 19 ページ ２００５年２月１４日 月曜日 午前９時４５分