Filter
Top Products
40
Chapter 1. Playing Back Songs
■
Adding Harmonies to the Mic Vocals (Harmony)
You can sing with a harmony accompaniment, even when you’re playing solo. This
is called the “Harmony” function.
1.
Press the [Function] (Exit) button so the indicator is lit.
2.
Press the [Song] (Select -) button or [ ] (Select +) button to display
the VOCAL screen.
fig.
3.
Press the [Song] (Select -) button or [ ] (Select +) button to get the
value for “Harmony” to flash.
fig.
4.
Press the [ ] (Value -) button or [ ] (Value +) button to change the
harmony settings.
5.
Press the [Function] (Exit) button so the indicator goes out.
Value
Description
Unison
Sounds like two people singing the same melody.
Oct Up
(Octave Up)
Adds another voice one octave higher than the original.
OctDwn
(Octave Down)
Adds another voice one octave lower than the original.
5th Up
Adds harmony a fifth above the original.
3rd Up
Adds harmony a third above the original.
4thDwn
(4th Down)
Adds harmony a major fourth below the original.
Data
As you sing along with the playback of the song data,
harmonies consistent with the scale of the specified part
are added.
Set the part to which harmonies are added in “Setting the
Part to Which Harmonies Are Added (Harmony Part)” (p.
95).
Off
No harmonies are added to the microphone vocals.
NOTE
Use of the Harmony function
may cause changes in the
Damper Resonance effect (p.
59).
NOTE
Depending on the type of
harmony, there may be some
songs to which harmonies
cannot be added.
You can change the settings for
the Harmony function with the
remote control’s [HARMONY]
b
utton (p. 34).
RG-7_e.book 40 ページ ２００５年２月１４日 月曜日 午前９時４５分