Filter
Top Products
36
Chapter 1. Playing Back Songs
Using the Aux Input Jack
1.
Press the [Function] (Exit) button so the indicator is lit.
2.
Press the [Song] (Select -) button or [ ] (Select +) button to display
the AUX INPUT screen.
3.
Press the [Song] (Select -) button or [ ] (Select +) button to get the
value for “Mode” to flash.
fig.
4.
Press the [ ] (Value -) button or [ ] (Value +) button to change
Aux Input type.
Value:
Off, Stereo, Decode
With the factory settings, this is set to “Off.” When set to “Off,” the Aux Input
connector cannot be used.
Set this to “Stereo” when using a connected MD player or other such device.
“Decode” is employed when inputting encoded signals; it is not normally used in
normal situations.
5.
Press the [Song] (Select -) button or [ ] (Select +) button to get the
value for “Level” to flash.
fig.
6.
Press the [ ] (Value -) button or [ ] (Value +) button to change the
Level of the device connected to Aux Input jack.
Value:
0–127
* When the level is set to “0,” sounds from the device connected to the Aux Input
jack are not played.
7.
Press the [Function] (Exit) button so the indicator goes out.
You can save this setting in the
RG-7’s memory using the
Memory Backup function (p.
72).
RG-7_e.book 36 ページ ２００５年２月１４日 月曜日 午前９時４５分