Roland AT15 Electronic Keyboard User Manual


 
16
Before You Start Playing
Setting Up the Music Stand
fig.01-03
1.
Attach the music stand by inserting it into the
two holes.
Connecting the Power Cord
1.
First, make sure that the [Power On] switch at
the panel’s left side is OFF (not pushed in).
2.
Connect the supplied power cord to the AC Inlet
connector, then plug the other end into an AC
outlet.
fig.01-04
* Only use the power cord supplied with this instrument.
* Whenever you do not intend to use the instrument for extended
periods of time, pull out the power cord from the AC outlet.
Turning the Power On and Off
* Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
Tuning On the Power
1.
Make sure of the following before the power is
turned on.
•Is the power cord correctly connected to the AC inlet?
•Is the power cord correctly connected to the AC outlet?
•Is the [Master Volume] knob (located at the left of the
Lower keyboard) set to the Min (minimum) position?
fig.01-05
2.
Press the [Power On] switch to turn on the
power.
The power will turn on, and the Basic Screen appears on
the display.
fig.01-06
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
3.
Turn the [Master Volume] knob or depress the
expression pedal to adjust the volume to a
suitable level.
Turning the [Master Volume] knob towards “Max”
increases the volume; turning the knob towards “Min”
decreases the volume. Likewise, pressing down on the
expression pedal increases the volume, while easing up
on the pedal decreases the volume.
fig.01-07
Turning Off the Power
1.
Before switching the power off, set the [Master
Volume] knob to the Min (minimum) position.
2.
Press the [Power On] switch to turn off the
power.
fig.01-06
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply” (p. 5).
MaxMin
Master Volume
ON
Lower position
increase
the volume
decrease
the volume
OFF
Upper position
AT-15_e.book 16 ページ 2005年1月21日 金曜日 午後8時14分