Filter
Top Products
51
Using the Registration Buttons
The AT-15 allows you to store sound settings and panel settings such as 8 in
the Registration buttons. There are a total of 8 Registration buttons, and one
set of panel settings can be stored in each, allowing you to register a total of
8 different panel settings. Each set of panel settings that has been stored in a
Registration button is called a “Registration.”
This provides a convenient way to change large numbers of panel settings
during a performance, or to recall a complex panel setting.
fig.07-01
Storing Registrations
1.
Make all the panel settings that you wish to store.
2.
While holding down the [Write] button, press one of the
Registration [1] – [8] buttons.
The panel settings will be stored in the selected Registration button.
6
Write
234 5 781
Manual
Settings that have been
stored to Registration [1]–
[8] buttons are remembered
even if the power is turned
off. If you wish to restore
the settings stored in the
Registration buttons to
their factory settings, use
the “Factory Reset”
operation (p. 17).
With the settings of
Registration [1] – [8]
buttons considered as one
set, a single floppy disk can
store up to 99 sets of data
(p. 56).
For details on the settings
that are stored in a
Registration, refer to
“Settings That Are Stored
in the Registration Buttons”
(p. 108).
AT-15_e.book 51 ページ ２００５年１月２１日 金曜日 午後８時１４分