Filter
Top Products
31
Creating/Editing Patches (Patch mode)
POLY PITCH SHIFTER
NATURAL VOICE
UNVOICE
Refer to
PITCH
(p. 27),
EQ GROWL
(p. 27),
TVA
(p. 27),
and
CTRL
(p. 28) in the “Carrier Screen.”
AutoNoteSw
If this is on, the pitch from the mic input will be detected,
allowing you to play the VC-2 without having to play the
keyboard (i.e., without inputting note data).
FmtKF
-200– +200 Specifies the amount by which the
formant value will be affected by
the key you play.
OSC 2
switch
OFF,
ON
Switches OSC2 on/off.
Parameter
Value Explanation
Level
0–127 Adjusts the output level of the poly pitch
shifter.
ModDepth -63–
+63
Adjust the output level of the poly pitch
shifter using the controller assigned by
Controller
(p. 31).
Parameter
Value Explanation
Level
0–127 Adjusts the output level of the natural
voice (your own unprocessed voice).
RevSend 0–127 Adjusts the reverb send level.
ModDepth -63–
+63
Adjust the output level of the natural
voice using the controller assigned by
Controller
(p. 31).
Parameter
Value Explanation
Level
0–127 Specifies the amount of the detected un-
voiced consonants that will be mixed into
the output of the vocoder.
Detect 1–50 Adjusts the sensitivity at which unvoiced
consonants are detected.
PITCH / EQ GROWL / TVA / CTRL
Parameter
Value Explanation
Controller
Select the controller used by ModDepth or ~ModDepth.
Parameters marked by * will not function since the
V-Synth XT (rack-mount) does not have the
corresponding controller. They will function if you
connect the V-Synth (keyboard) to the V-Synth XT as
an external MIDI controller.
OFF: Control will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
BEND: Pitch Bend, AFT: Aftertouch
+PAD-X*: The center of the time trip pad is 0; toward the
right is +, and toward the left is -
+PAD-Y*: The center of the time trip pad is 0; upward is
+, and downward is -
PAD-X*: The left edge of the time trip pad is 0; toward the
right is +
PAD-Y*: The bottom edge of the time trip pad is 0;
upward is +
TRIP-R*: The outer edge of the time trip pad is 0; toward
the center is +
BEAM-L*: D Beam controller (left)
BEAM-R*: D Beam controller (right)
KNOB1*: C1 knob
KNOB2*: C2 knob
VELO: Velocity
KEYF: Key Follow
* VELO and KEYF do not exist in the wave screen
Controller or for patches whose patch algorithm is
Processor~.
BREATH: Volume of the mic input → Breath (p. 39)
vc2_for_XT_e1 31 ページ ２００５年３月８日 火曜日 午後４時５２分