Roland VC-2 Recording Equipment User Manual


 
39
Settings Common to All Modes (System Mode)
Audio I/F
Tx
Breath
STORE
Store the chord you specified from the
keyboard into the chord set.
Parameter
Value Explanation
MIC Jack
Switch
OFF, ON Specifies whether the front pan-
el MIC jack will be enabled
(ON) or disabled (OFF).
INPUT Jack
Switch
OFF, ON Specifies whether the rear panel
INPUT jacks will be enabled
(ON) or disabled (OFF).
INPUT Jack
Gain
0db, +12db Sets the gain of the rear panel
INPUT jacks.
USB Audio In-
put Source
OFF, MAIN,
ANALOG
When the V-Synth XT is con-
nected via USB to your comput-
er, this specifies the source of
the USB audio that will be out-
put to the computer.
USB Audio In-
put Monitor
Sw
OFF, ON Specifies whether USB Audio
Input Source monitoring will be
sent from the V-Synth XT’s
MAIN OUT (ON) or will not be
sent (OFF).
USB Audio
Output Dest
OFF, MAIN,
DIR
When the V-Synth XT is con-
nected via USB to your comput-
er, this specifies the output
destination of the USB audio
that is received from the com-
puter.
Parameter
Value Explanation
Front Panel
Sound
Generator
MIC Jack
INPUT
Jack
R
L
INPUT
JACK
Gain
INPUT
JACK
Switch
MIC
JACK
Switch
MIC Sw
•Hi-Z
•NORMAL
•PHANTOM
Input Knob PEAK LED
Rear Panel
Carrier
(Processor
Type 1, 2)
Modulator (MIC)
Controller Settings (Controller)
Parameter Value Explanation
Patch Tx
Ch
1–16,
RX CH,
OFF
Specifies the transmit channel of MIDI
messages in Patch mode. If you do not
want to transmit MIDI messages to ex-
ternal MIDI devices, turn this parameter
“OFF.” If you want the transmit channel
to always match the Patch Receive
Channel, set this parameter to “RX CH.”
Tx PC OFF,
ON
Specifies whether Program Change mes-
sages will be transmitted (ON) or not
(OFF).
Tx Bank OFF,
ON
Specifies whether Bank Select messages
will be transmitted (ON) or not (OFF).
Tx Active
Sens
OFF,
ON
Specifies whether Active Sensing mes-
sages will be transmitted (ON) or not
(OFF).
Parameter
Value Explanation
Voice As-
sign
OFF,
CC01–31,
CC33–95
Specifies the MIDI controller
number that will transmit the
volume data extracted from the
mic input signal.
OFF
: No message will be trans-
mitted.
CC01-31, 33-95
: Controller
numbers 1-31, 33-95
Parameter
Value Explanation
INPUT
Jack
MIC
Jack
DIRECT
OUT
OFF
ANALOG
MAIN
DIR
MAIN
V-Synth XT
USB Audio OUT USB Audio IN
USB Audio Output Dest
USB Audio Input Source
MAIN
OUT
INPUT
Monitor
Switch
Sound Generator
vc2_for_XT_e1 39 ページ 2005年3月8日 火曜日 午後4時52分