Filter
Top Products
67
Effects List
14: Garage
This simulates the reverberation of a garage. It produces the
reverberation of a room surrounded by hard-surfaced walls
with many reflections.
Parameter
Value Description
Pre Low Freq
50–4000 Hz Frequency of the low range
Pre Low Gain -15– +15 dB Gain of the low range
Pre Mid Freq 50–20000 Hz Frequency of the middle range
Pre Mid Q 0.5, 0.7, 1.0, 2.0,
4.0, 8.0
Width of the middle range
Set a higher value for Q to nar-
row the range to be affected.
Pre Mid Gain -15– +15 dB Gain of the middle range
Pre Hi Freq 2000–20000 Hz Frequency of the high range
Pre Hi Gain -15– +15 dB Gain of the high range
Rev Time 0.06–32.0 sec Duration (time) of the reverb
Pre Dly Time 0–200.0 ms Adjusts the delay time from the
direct sound until the reverb
sound is heard.
Density 0–99 Density of the reverb
Room Size 1–8 Size of the room which is simu-
lated
Early Ref Lev-
el
0–99 Volume level of the initial reflect-
ed sound
Release Densi-
ty
0–99 Density of the sound that reaches
the listener after many repeated
reflections
Low Damp
Freq
50–4000 Hz Adjusts the frequency below
which sound fed back to the ef-
fect will be cut.
The Low Damp function damps
the low frequency band of the re-
verb sound quicker than other
bands.
Low Damp
Gain
-36–0 dB Degree of Low Damp
Hi Damp Freq 2000–20000 Hz Adjusts the frequency above
which sound fed back to the ef-
fect will be cut.
High Damp, by attenuating the
higher frequencies first.
Hi Damp Gain -36–0 dB Degree of High Damp
Post HC Freq 160–15000 Hz,
THRU
Frequency at which the high cut
filter will begin to take effect
(THRU: no filter is used)
vc2_for_XT_e1 67 ページ ２００５年３月８日 火曜日 午後４時５２分