Filter
Top Products
57
Effects List
34: Guitar Multi
Guitar Multi provides Comp/Limiter, Overdrive or
Distortion, Chorus or Flanger, and Delay effects connected in
series.
Enhan Sens
0–127 Sensitivity of the enhancer
Enhan Fre-
quency
0–127 Sets the lower limit of the frequen-
cies to which the enhancement ef-
fect is added.
Enhan Mix
Level
0–127 Level of the overtones generated
by the enhancer
Enhan Level 0–127 Volume of the enhancer sound
EQ Low Freq 50–4000 Hz Frequency of the low range
EQ Low Gain -15– +15 dB Gain of the low range
EQ Mid Freq 50–20000 Hz Frequency of the middle range
EQ Mid Q 0.5, 0.7, 1.0, 2.0,
4.0, 8.0
Gain of the middle range
Set a higher value for Q to narrow
the range to be affected.
EQ Mid Gain -15– +15 dB Gain of the middle range
EQ Hi Freq 2000–20000 Hz Frequency of the high range
EQ Hi Gain -15– +15 dB Gain of the high range
Delay Time 0–1300 ms,
note
Adjusts the delay time from the di-
rect sound until the delay sound is
heard.
Delay Feed-
back
-98– +98 % Adjusts the proportion of the de-
lay sound that is fed back into the
effect. Negative (-) settings will in-
vert the phase.
Low Damp
Freq
50–4000 Hz Adjusts the frequency below
which sound fed back to the effect
will be cut.
The Low Damp function damps
the low frequency band of the de-
lay sound quicker than other
bands, which makes for a clearer
delay effect.
Low Damp
Gain
-36–0 dB Degree of Low Damp
Hi Damp
Freq
2000–20000 Hz Adjusts the frequency above
which sound fed back to the effect
will be cut.
High Damp, by attenuating the
higher frequencies first, makes the
delay sound more natural.
Hi Damp
Gain
-36–0 dB Degree of High Damp
Delay Level 0–127 Volume of the delay sound.
Parameter Value Description
Comp Sw OFF, ON Turns the comp/limiter on/off.
Comp
Threshold
-60–0 dB Sets the volume level at which the
compression begins.
Comp At-
tack
0–127 Sets the time after the sound vol-
ume is crossed the compressor
threshold until compression be-
gins.
Parameter
Value Description
Comp Re-
lease
0–127 Specifies the time from when the
volume drops below the compres-
sor threshold until compression is
no longer applied.
Comp Ratio 1.5:1, 2:1, 4:1,
100:1
Sets the “source sound:output
sound” compression ratio.
Comp Gain -60– +12 dB Adjusts the output gain.
Od/Ds Sw OFF, ON Selects whether to use overdrive or
distortion.
Drive Mode OD, DS Selects whether to use overdrive
(OD) or distortion (DS).
Drive 0–127 Degree of distortion
Amp Sim Sw OFF, ON Turns the amp simulator on/off.
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Distortion
(DS) Level
0–127 Volume of the overdrive or distor-
tion sound.
Mod Mode CHORUS,
FLANGER
Selects whether to use chorus or
flanger.
Mod Rate 0.05–10.0 Hz,
note
Adjusts the speed of modulation
for the chorus or flanger.
Mod Depth 0–127 Adjusts the depth of modulation
for the chorus or flanger.
Mod Phase 0–180 deg Sets how the chorus or flanger
sound is spread.
Mod Pre De-
lay
0–50.0 ms Adjusts the delay time from the di-
rect sound until the chorus or
flanger sound is heard.
Mod Feed-
back
-98– +98 % Adjusts the proportion of the effect
sound that is fed back into the ef-
fect. Negative (-) settings will in-
vert the phase.
Mod Xover-
LPF
500–15000 Hz,
THRU
Adjusts the cutoff frequency of the
low pass filter. (THRU: no filter is
used)
Mod Xover-
HPF
THRU,
50–800 Hz
Adjusts the cutoff frequency of the
high pass filter. (THRU: no filter is
used)
Mod Level 0–127 Volume of the chorus or flanger
sound.
Delay Time 0–1300 ms,
note
Adjusts the delay time from the di-
rect sound until the delay sound is
heard.
Delay Feed-
back
-98– +98 % Adjusts the proportion of the delay
sound that is fed back into the ef-
fect. Negative (-) settings will in-
vert the phase.
Hi Damp
Freq
500–15000 Hz,
THRU
Adjusts the frequency above which
sound fed back to the effect will be
cut.
High Damp, by attenuating the
higher frequencies first, makes the
delay sound more natural.
Delay Level 0–127 Volume of the delay sound.
Parameter
Value Description
vc2_for_XT_e1 57 ページ ２００５年３月８日 火曜日 午後４時５２分