Filter
Top Products
Using the Line Outputs
The KM200 provides a stereo Line Output for sending to a main PA mixer or recorder.
• Connect the XLR or 1/4-inch Left and Right Line Outputs to a stereo input on your
main PA mixer.
• You can also use the Line Output ON/OFF switch to mute the mix going to out the
line input for time that you are setting up sound and don’t want you mix to play
through.
Note: Be careful to watch the position of this switch to avoid driving your soundman crazy
Using the In To Headphones Level
The Headphones Level control is used to set the level sent to the headphone
jack.
Using the In To Phone Only
The KM200 provides a convenient patch point for inserting a stereo signal that will
only be heard in the headphone output. This is especially useful for connecting a met-
ronome click track, or the feed from the main PA’s monitor mix.
Connect a mono or stereo signal to the In To Phone Only 1/4-inch TRS input jack.
Now, use the Into Phones Only Level control to blend in the signal with the normal
instrument mix.
Using the Stereo Link Connections
You can use two KM200’s together or a stereo keyboard amplification system using the
Stereo Link Connections.
First decide which amplifier you will use for connecting your instruments. This will be
the Left side amplifier and speaker, so connect your instruments here.
Now, run a standard 1/4-inch instrument cable, or a balance TRS (TIP RING SLEEVE)
1/4-inch cable, from the left KM200’s (the one you connected your instruments to)
Stereo Link Output to the Stereo Link Input on the second, right side, KM200.
Be sure to set both KM200’s main Volume controls to the same level to insure the
proper stereo balance.
Once you have both of the KM200’s main Volume controls set, use the channel volume
controls on the Left KM200 to adjust your instrument mix.
Setting Up and Using the KM200
Left KM200 Right KM200
ENGLISH
9