Filter
Top Products
Guided Tour - KM200 Front Panel
1. Channel 1 Volume - Control knob is used to control the overall level of the
Channel 1 input.
2. Bass – This knob controls the low band of the Channel Equalizer, +/- 15 dB
at 80Hz.
3. Treble – This knob controls the high band level of the Channel Equalizer,
+/- 15 dB at 10K.
4. Channel 2 Volume – This control knob used to control the overall level of
the Channel 2 input.
5. Channel 3 Volume - Control knob is used to control the overall level of the
Channel 3 input.
6. Channel 4 Volume – This control knob is used to control the overall level
of the Channel 4 input.
7. Graphic Equalizer - These sliders allow you to “draw” the tonal response
of the system by adding 12 dB of boost or attenuation to seven different
narrow-band frequency areas (100 Hz, 250 Hz, 500 Hz, 1 kHz, 2.5 kHz, 5 kHz,
and 10 kHz), affecting the main output signal of the KM200. When a slider
is at its center detented (“0”) position, the selected frequency area is unaf-
fected (it is said to be flat). When a slider is moved up (above the “0” position,
towards the “+15” position), the selected frequency area is boosted, and when
it is moved down (below the “0” position, towards the “-15” position), the
selected frequency area is attenuated. For more information, see the “About
Equalization” section on pages 12 - 13 of this manual.
8. Headphones - Adjusts the volume of the headphones.
ENGLISH
3