Filter
Top Products
19
Keypad Function
The keypad is used for both numeric and alpha character entry. When pressed, each alphanumeric button will display its corresponding
number. If pressed again within two seconds the unit will display the first corresponding letter for that key. Repeat this process for
additional letters on the same key. A space may be inserted by pressing the 0 key twice. To go back, use the back arrow. The Cal=Trak will
overwrite previous entries. Use the Enter key to lock in any selections.
Reset Button
Clears both the current reading and the group average and opens the valve, allowing the piston to return to its
resting state.
Stop Button
Stops current reading and opens the valve, allowing the piston to return to its resting state.
Auto Button
Initiates automatic readings (must be accessed from the “Run Menu”). If the Reading type has been set to “Cont” in “Setup Menu – 2”, the
unit will run until the preset average is reached and then start the cycle over. If the Reading type has been set to “Burst” in “Setup Menu –
2”, the unit will run until the preset average is reached and then stop.
Read Button
Initiates a single reading (must be accessed from the “Run Menu”).
8.3 Factory Default Settings
The Sierra Cal=Trak has a number of user definable features and settings. To return to factory default settings press Reset followed by Save
from the “Main Menu”
Parameters Factory Settings Optional Settings
No. of Readings in an Averaging Sequence 10 1–100
Atmospheric Pressure mm Hg mBar, kPa, PSI
Temperature °C °F
Standardized Temperature Setting 0 °C 0.0–50.0 °C
Date Format MM/DT/YR DT/MM/YR
Time Format AM/PM 24 Hr
8.4 Taking Readings
1 Press Enter, Read, or Auto to enter the “Run Menu”.
Ma
i
n Menu
Run
Setup
Leak Tes
t