Filter
Top Products
Direct Pro 24/96 Owner’s Manual
8
Windows 95 Software Setup (cont'd) Samplitude Basic
29
4. When the files have been copied, Windows will ask to restart the computer. This is because the files
just installed will not take effect until the next time Windows is loaded. Click NO, since you will restart
the computer after completing the Direct Pro 24/96 software installation in the next section.
WINDOWS 95 SOFTWARE SETUP
5. Once Windows has finished loading, the Direct Pro 24/96 Control Panel installation program may
appear automatically. If not, go to My Computer, find your CD-ROM drive, and click the setup.exe
icon.
6. Click Next when you see the welcome screen:
7. Setup will allow you to select the Destination Directory. Otherwise, it will put the Direct Pro 24/96
software and drivers in the “C:\Program Files\Aark manager” directory. If you would like the files
elsewhere, simply type the new destination or select Browse to put the files in another directory.
8. Click the Next button to continue. The Ready to Install!! Dialog should now appear. Click Next again
to begin installation.
EXTERNAL MIXDOWN:
If you want to mix down a song through a mixer, routing
the computers output channels to separate outputs, con-
figure the patchbay in this manner.
SAMPLITUDE BASIC
Samplitude Basic is a feature-filled introduction to the full Sek’d Samplitude line that includes Samplitude
Studio and Samplitude 2496. A complete manual can be found on the Samplitude Basic CD-ROM, along
with a multimedia tutorial that will prepare you for working on any Samplitude project.
This is an example of a typical setup for recording stereo multitrack in Samplitude . Samplitude and the
Aark 24 are not limited to this configuration.
1. Plug outputs 1-2 into your amplifier/mixer. In the direct pro control panel, go to the patchbay, and drag
Monitor L,R to all 3 output pairs.
2. Open Samplitude. As soon as it opens,
there will be a Record Parameter window.
Click OK.
3. Go to FILE | OPEN NEW MULTITRACK
PROJECT(VIP), Select “8 Tracks” under Mono
L & R.
4. Go to WINDOW | MIXER. A mixer win-
dow should appear. Click on the ? under Mas-
ter Volume + Image. This will bring up a play
parameter window. Set the device to 1,2 Di-
rect Pro then close the window. Now, the
mixer window can be closed as well.
5. Clicking the ? symbol by each track opens
a Track Info window for that particular track.