Filter
Top Products
Connecting the X2
20 X2 Reference Manual
indicate that an outlet is properly grounded. You may use an AC line tester to
determine this. If the outlet is not grounded, consult with a licensed electrician.
When AC currents are suspected of being highly unstable in VAC and Hz, a
professional power conditioner should be used.
To connect the power supply to the X2:
1 Screw on one end of the multipin cable to the X2’s POWER connector, and the
other end to the same type connector on the back of the power supply unit.
You will find the X2’s power supply connector on the left side of the rear panel.
2 Attach the female end of the AC power cord to the power supply unit and the
male end to a good quality, noise-free AC power source of the proper rating.
3 To apply power to the X2, switch on the POWER switch of the power supply
unit, so that it is in the | (on) position.
Do not operate any electrical equipment with ungrounded outlets. Plugging the X2 into an
ungrounded outlet, or “lifting” the unit off ground with a three-to-two wire adapter, can
create a hazardous condition.
Alesis cannot be responsible for problems caused by using the X2 or any associated
equipment with improper AC wiring.
J
J