Filter
Top Products
Specifications
X2 Reference Manual 95
SPECIFICATIONS
All measurements taken with an Audio Precision System One. All noise
measurements taken with trim at minimum and faders at unity gain with 22 Hz to
22 kHz bandwidth unless otherwise specified. All Tape In & Out measurements
made on balanced +4 dBu connectors. (+4 dBu into a line input with minimum trim &
faders at unity “0” will yield +4 dBu at any balanced output.)
Frequency Response: 10 Hz – 75 kHz ± 1 dB (any input to any
output @ nominal operating levels)
Noise:
MIC/LINE to Tape Out -85 dBu
MIC/LINE to L/R Master Out -85 dBu
MIC/LINE to Tape Out via Group -81 dBu
Tape In to Tape Out -85 dBu
Tape In to L/R Master Out -87 dBu
Tape In to Tape Out via Group -82 dBu
Mix Output Noise:
24 Tape Inputs assigned to L/R Master Out -74 dBu
Signal to Noise:
MIC/LINE to L/R Master Out 89 dB
Dynamic Range:
MIC/LINE to L/R Master Out 113 dB
Headroom:
Internal to Console 24 dB
External above +4 dBu Balanced Outputs 24 dB
Maximum Output Level:
Balanced Outputs into 10k ohm Load +28 dBu
Balanced Outputs into 600 ohm Load +26 dBu
THD + Noise @ 1 kHz (+20 dBu Input - Unity Gain):
MIC/LINE to Tape Out <0.005%, 0.003% typical
MIC/LINE to L/R Master Out <0.005%, 0.003% typical
Tape In to L/R Master Out <0.004%, 0.002% typical
Attenuation (1 kHz):
CHANNEL fader >83dB, 88 dB typical
CHANNEL MUTE AUTOMATION >95 dB, 100 dB typical
BUSS ASSIGN ISOLATION >100 dB, 103 dB typical
CROSSTALK 70 dB typical
Equivalent Input Noise (22 Hz to 22 kHz):
MIC w/ 150 ohm termination -128 dBu
Input Levels: