Filter
Top Products
148 Chapter 12—Effects
01V—Owner’s Manual
DYNA.PHASER
Dynamically controlled phaser.
REV+CHORUS
Reverb and chorus effects in parallel.
1. 6.0 ms–46.0 s (fs=44.1 kHz), 5.0 ms–42.3 s (fs=48kHz)
1.
2. For more information about the FREQ., NOTE, and TEMPO parameters, see “Setting
Delay, Freq, Note & Tempo Parameters” on page 137.
Parameter Range Description
SOURCE INPUT, MIDI Control source: input signal or MIDI note on velocity
SENSE 0–100 Sensitivity
FB GAIN –99 to +99%
Feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase feedback)
OFFSET 0–100 Lowest phase-shifted frequency offset
DIR. UP, DOWN Upward or downward frequency change
STAGE 2, 4, 8, 10, 12, 14, 16 Number of phase shift stages
DECAY
*1
Decay speed
Parameter Range Description
REV TIME 0.3–99.9 s Reverb time
INI.DLY 0.0–500.0 ms Initial delay before reverb begins
HI.RATIO 0.1–1.0 High-frequency reverb time ratio
DENSITY 0–100% Reverb density
FREQ. 0.05–40.00 Hz Modulation speed
NOTE
*1
Used in conjunction with TEMPO to determine FREQ.
DEPTH 0–100% Modulation depth
MOD.DLY 0.0–500.0 ms Modulation delay time
WAVE Sine, Tri Modulation waveform
REV/CHO 0–100%
Reverb and chorus balance (0% = chorus, 100% =
reverb)
HPF Thru, 21 Hz–8.0 kHz High-pass filter cutoff frequency
LPF 50 Hz–16.0 kHz, Thru Low-pass filter cutoff frequency
TEMPO
*2
25–300 bps Used in conjunction with NOTE to determine FREQ.