Filter
Top Products
236 Chapter 17—MIDI
01V—Owner’s Manual
MIDI Machine Control
Using MIDI Machine Control (MMC) commands, an MMC-compatible recorder can
be controlled from the 01V. [ON] buttons 1 through 6 can be used to control transport
functions, while [SEL] buttons 1 through 6 can be used to locate six definable locate
points. MMC commands are transmitted via MIDI.
1. Use the [REMOTE] button to locate REMOTE page 2, as shown below.
While this page is displayed, controls other than [ON] buttons 1 through 6 and [SEL]
buttons 1 through 6 are disabled.
2. Use the cursor buttons to select the DEVICE No. parameter, and the
PARAMETER wheel or [–1/DEC] and [+1/INC] buttons to select a device
number.
The device number, which can be set from 1 through 127 or ALL, should be set to
match that of the recorder you want to control. When set to ALL, all MMC-compatible
recorders connected can be controlled together.
3. Use [ON] buttons 1 through 6 to transmit the following transport com-
mands to a recorder.
4. Use the cursor buttons and PARAMETER wheel or [–1/DEC] and [+1/INC]
buttons to set the locate times in hours, minutes, seconds, and frames.
5. Use [SEL] buttons 1 through 6 to transmit the locate commands to the
recorder.
Locate points can be stored using MIDI Bulk Dump. See “Bulk Dump” on page 232 for
more information.
On Button Function MMC Command Value
1 Rewind 05
2 Fast Forward 04
3 Stop 01
4 Play 02
5 Pause 09
6 Record 06