Filter
Top Products
32 Chapter 4—Getting Around the User Interface
01V—Owner’s Manual
Fader Modes
The 01V [SEL], [SOLO], and [ON] buttons, channel faders, and STEREO (MASTER)
fader are multifunction controls, and their exact operation depends on the selected
Fader mode. Operation of these controls is shown in the following tables.
SEL Buttons
The [SEL] buttons are used to select channels for EQ, Pan, Dynamics, and Routing
operations. The following channels can be selected:
•
CH1 through CH24—Input channels 1 through 24
•
ST—Stereo output
•
RTN1, RTN2—Effects returns 1 and 2
•
AUX1 through AUX4—Aux sends 1 through 4
•
EFF1, EFF2—Effects sends 1 and 2
•
1–16, MAS—Remote function channels
The [SEL] buttons are also used to make and release channel pairs and fader and mute
groups (“Grouping Faders” on page 55 and “Grouping Mutes” on page 56).
Input Channel [SEL] button Examples
To select the EQ function for input channel 3, press the [HOME] button, and then press
[SEL] button 3 (CH3 appears in the bottom right corner of the display). Use the
SELECTED CHANNEL F and G controls to adjust the EQ. (If a fader mode other than
Option I/O or Remote is selected, it’s not necessary to press the [HOME] button.)
To select the Pan function for input channel 13, press the [HOME] button, and then
press [SEL] button 13/14 repeatedly until CH13 appears on the display. Use the
SELECTED CHANNEL PAN control to adjust the pan. Since most functions on input
*1. CH17–20 with four-input Option I/O cards.
Fader Mode
SEL button
1–8
[17–24]
9–12 13/14
15/16
STEREO
[MASTER]
RETURN 1/2
HOME
CH 1–16 select
STEREO OUT
select
RETURN 1/2
select
AUX 1
AUX 1
master select
AUX 2
AUX 2
master select
AUX 3
AUX 3
master select
AUX 4
AUX 4
master select
EFFECT 1
EFFECT 1
master select
EFFECT 2
EFFECT 2
master select
OPTION I/O
CH 17–24
*1
select
— — STEREO select
REMOTE 1
Internal parameter assign select —
REMOTE 2
MMC (1–6) —
REMOTE 3
User defined MIDI controller select —