Filter
Top Products
282 MIDI Data Format
01V—Owner’s Manual
PARAMETER CHANGE (7bit operation for type
0x10:edit buffer)
Reception
This message is received if [Parameter Change RX] is ON and the [Rx
CH] matches the Device Channel included in the SUB STATUS.
This is echoed if [Parameter Change ECHO] is ON.
When this is received, the specified parameter will be controlled.
Transmission
If [Parameter Change TX] is ON, this message is transmitted on the
[Tx CH] Device Channel when a parameter not specified in the
[Control Assign Table] is modified.
The valid range of addresses is 0x0000 - 0x03FF
PARAMETER CHANGE (bit operation for type
0x40:edit buffer)
Reception
When [Parameter Change RX] is ON, this message is received if the
[Rx CH] matches the Device Channel included in the SUB STATUS.
If [Parameter Change ECHO] is ON, this message will be echoed.
When this message is received, the specified parameter will be con-
trolled.
Transmission
If [Parameter Change TX] is ON, this message is transmitted on the
[Tx CH] Device Channel when a parameter not specified in the
[Control Assign Table] is modified.
The valid range of addresses is 0x0000 - 0x03FF
PARAMETER CHANGE (byte operation for type
0x01:system memory)
Reception
When [Parameter Change RX] is ON, this message is received if the
[Rx CH] matches the Device Channel included in the SUB STATUS.
When [Parameter Change ECHO] is ON, this is echoed.
When this is received, the specified parameter will be controlled.
The system memory will depend on the address, as follows.
PARAMETER CHANGE (bit operation for type
0x41:system memory)
Reception
When [Parameter Change RX] is ON, this message is received if the
[Rx CH] matches the Device Channel included in the SUB STATUS.
When [Parameter Change ECHO] is ON, this is echoed.
When this is received, the specified parameter will be controlled.
The system memory will depend on the address, as follows.
STATUS 11110000 F0 System Exclusive Message
ID No. 01000011 43 Manufacturer's ID No.(YAMAHA)
SUB STATUS 0001nnnn 1n parameter change n=0-15(Device Chan-
nel No.1-16)
GROUOP ID 00111110 3e MODEL ID
MODEL ID 00000100 04 Device code (01V)
PARAM TYPE 00010000 10 7bit operation for edit buffer (type)
DATA 0aaaaaaa dd0 address( H) high 7 bits of 14 bits address
0aaaaaaa dd1 address( L) low 7 bits of 14 bits address
0ddddddd dd2 data 7bit
: :
EOX 11110111 F7 End Of Exclusive
STATUS 11110000 F0 System Exclusive Message
ID No. 01000011 43 Manufacturer's ID No.(YAMAHA)
SUB STATUS 0001nnnn 1n parameter change n=0-15(Device Chan-
nel No.1-16)
GROUOP ID 00111110 3e MODEL ID
MODEL ID 00000100 04 Device code (01V)
PARAM TYPE 01000000 40 bit operation for edit buffer (type)
DATA 0aaaaaaa dd0 address( H) high 7 bits of 14 bits address
0aaaaaaa dd1 address( L) low 7 bits of 14 bits address
0ddddddd dd2 data(bit0-2:change bit no.0-7, bit3:0=reset
1=set)
: :
EOX 11110111 F7 End Of Exclusive
STATUS 11110000 F0 System Exclusive Message
ID No. 01000011 43 Manufacturer's ID No.(YAMAHA)
SUB STATUS 0001nnnn 1n parameter change or response
n=0-15(Device Channel No.1-16)
GROUOP ID 00111110 3e MODEL ID
MODEL ID 00000100 04 Device code (01V)
PARAM TYPE 00000001 01 byte operation for system memory (type)
DATA 0aaaaaaa dd0 address( H) high 7 bits of 14 bits address
0aaaaaaa dd1 address( L) low 7 bits of 14 bits address
0000dddd dd2 data( H) high 4 bits of 8 bits data
0000dddd dd3 data( L) low 4 bits of 8 bits data
: : continuous address datas
EOX 11110111 F7 End Of Exclusive
0x0000 - 0x007F : setup memory(128byte)
0x0080 - 0x0147 : backup memory(200byte)
0x0200 : card type(1byte)
STATUS 11110000 F0 System Exclusive Message
ID No. 01000011 43 Manufacturer's ID No.(YAMAHA)
SUB STATUS 0001nnnn 1n parameter change or response
n=0-15(Device Channel No.1-16)
GROUOP ID 00111110 3e MODEL ID
MODEL ID 00000100 04 Device code (01V)
PARAM TYPE 01000001 41 bit operation for system memory (type)
DATA 0aaaaaaa dd0 address( H) high 7 bits of 14 bits address
0aaaaaaa dd1 address( L) low 7 bits of 14 bits address
0ddddddd dd2 data(bit0-2:change bit no.0-7, bit3:0=reset
1=set)
: :
EOX 11110111 F7 End Of Exclusive
0x0000 - 0x007F : setup memory(128byte)
0x0080 - 0x0147 : backup memory(200byte)