Filter
Top Products
156 Chapter 12—Effects
01V—Owner’s Manual
DIST->DELAY
Distortion and delay effects in series.
MULTI FILTER
Three-band parallel filter (24 dB/octave)
1. (Maximum value depends
on the tempo setting)
2.
3. For more information about the DELAY, NOTE, and TEMPO parameters, see “Setting
Delay, Freq, Note & Tempo Parameters” on page 137.
Parameter Range Description
DST TYPE
DST1, DST2, OVD1,
OVD2, CRUNCH
Distortion type (DST = distortion, OVD = overdrive)
DRIVE 0–100 Distortion drive
MASTER 0–100 Master volume
TONE –10 to +10 Tone control
N.GATE 0–20 Noise reduction
DLY BAL 0–100%
Distortion and delay balance (0% = distortion, 100%
= delayed distortion)
DELAY 0.0–2725.0 ms Delay time
DLY NOTE
*1
Used in conjunction with TEMPO to determine DELAY
FB.GAIN –99 to +99%
Feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase feedback)
HI.RATIO 0.1–1.0 High-frequency feedback ratio
FREQ. 0.05–40.00 Hz Modulation speed
MOD
NOTE
*2
Used in conjunction with TEMPO to determine FREQ.
DEPTH 0–100% Modulation depth
TEMPO
*3
25–300 bps
Used in conjunction with NOTE parameters to
determine DELAY and FREQ.
Parameter Range Description
TYPE 1 HPF, LPF, BPF Filter 1 type: low pass, high pass, band pass
TYPE 2 HPF, LPF, BPF Filter 2 type: low pass, high pass, band pass
TYPE 3 HPF, LPF, BPF Filter 3 type: low pass, high pass, band pass
FREQ. 1 28 Hz–16.0 kHz Filter 1 frequency
FREQ. 2 28 Hz–16.0 kHz Filter 2 frequency
FREQ. 3 28 Hz–16.0 kHz Filter 3 frequency
LEVEL 1 0–100 Filter 1 level
LEVEL 2 0–100 Filter 2 level
LEVEL 3 0–100 Filter 3 level
RESO. 1 0–20 Filter 1 resonance
RESO. 2 0–20 Filter 2 resonance
RESO. 3 0–20 Filter 3 resonance