Yamaha Digital Mixing Console DJ Equipment User Manual


 
Monitor Outputs 77
01V—Owner’s Manual
Monitor Outputs
Monitor and solo signals are output via the monitor out and phones connections. Make
sure the MONITOR–2TR IN switch is set to MONITOR for monitoring. See
“Two-track Input (2TR IN)” on page 77 for more information.
Monitor signals are converted to analog using 18-bit 8-times
oversampling D/A converters, and then output via balanced
1/4-inch phone jacks with a +4 dB nominal output level.
The MONITOR OUT LEVEL control is used to adjust the level
of the monitor out signal.
Phones
A pair of stereo headphones can be connected to the PHONES
stereo (TRS) phone jack. The phones signal is the same as the
monitor out signal.
The PHONES LEVEL control is used to adjust the level of the
phones signal.
Two-track Input (2TR IN)
Signals connected via the 2TR IN jacks can be monitored via the
MONITOR OUT and PHONES when the MONITOR–2TR IN
switch is set to 2TR IN. The stereo outputs of a master recorder
can be connected here for confidence monitoring and master
playback. The 2TR IN uses phono jacks with a –10 dBV nominal
input level.
By setting the 15/16–2TR IN switch to 2TR IN, 2TR IN signals
can be fed to input channels 15 and 16 for mixing with other sig-
nals. Normally, the input signals for these input channels are
derived from phone jack inputs 15 and 16.
The 2TR OUT jacks are explained on page 88.
MONITOR OUT
+4dB(BAL)
LR
LEVEL
MONITOR
OUT
100
PHONES
LEVEL
PHONES
100
2TR
L
R
IN OUT
–10dBV (UNBAL)
MONITOR
2TR IN
15/16
2TR IN