Filter
Top Products
42
Specifications
General specifications
0 dB is referenced to 0.775 Vrms.
Total Harmonic Distortion Less than 0.1% (THD+N)
(Master output) 20 Hz–20 kHz @ +14 dB 600 Ω
Frequency Response 0+1, –3 dB
(Master Output) 20 Hz–20 kHz @ +4 dB 600 Ω
Hum & Noise (20 Hz–20 kHz)*1
–128 dB Equivalent Input Noise.
Rs = 150 Ω –97 dB Residual Output Noise.
(MATRIX OUT)
Input Gain = Max. –99 dB Residual Output Noise. (OTHERS)
Input Pad = OFF
||
Input sensitivity=–60 dB
–64 dB(68 dB S/N) MIX OUT Master Level control and one Ch
fader at nominal level.
–80 dB(84 dB S/N) STEREO OUT Master fader at nominal level
and all Ch assign SW’s off and all MIX to ST
SW’s off.
–75 dB(79 dB S/N) MIX OUT(VARIABLE) Master Level control at
nominal level and all Ch assign SW’s off.
–81 dB(85 dB S/N) MIX OUT(FIX) Master Level control at nomi-
nal level and all Ch assign SW’s off.
–90 dB(94 dB S/N) MATRIX OUT Master level control at nominal
level and all Matrix Mix controls at minimum
level.
Crosstalk –80 dB @ 1 kHz adjacent inputs.
–70 dB @ 1 kHz input to output.(CH INPUT)
–50 dB @ 1 kHz input to output.(ST CH INPUT)
Maximum Voltage Gain
70 dB CH INPUT to DIRECT OUT
60 dB CH INPUT to CH INSERT OUT
80 dB CH INPUT to MIX OUT(VARIABLE, Pre
Fader)
90 dB CH INPUT to MIX OUT(VARIABLE, Post
Fader)
84 dB CH INPUT to MIX OUT(FIX;1–8, Post Fader)
84 dB CH INPUT to STEREO A OUT(CH to ST)
80 dB CH INPUT to STEREO B OUT(CH to ST)
100 dB CH INPUT to STEREO A OUT(VARIABLE,
MIX;Post Fader) (via MIX to ST)
96 dB CH INPUT to MATRIX OUT(VARIABLE,
MIX;Post Fader)(via MIX to MATRIX)
70 dB CH INPUT to MONITOR OUT(PFL)
47 dB ST CH A INPUT to MIX OUT(VARIABLE;1–
12, Pre Fader)
54 dB ST CH A INPUT to MIX OUT(FIX;1–8)
44 dB ST CH B INPUT to MIX OUT(FIX;1–8)
70 dB TALKBACK IN to MIX OUT
6 dB SUB IN to STEREO B OUT, MONITOR OUT,
MATRIX OUT
10 dB SUB IN to STEREO A OUT, MIX OUT
6 dB 2TR IN 1 to MONITOR OUT
17.8 dB 2TR IN 2 to MONITOR OUT
CH INPUT PAD SW 26 dB
CH INPUT GAIN control 44 dB variable
ST CH INPUT GAIN control
40 dB variable (ST CH A INPUT)
30 dB variable (ST CH B INPUT)
CH INPUT High Pass Filter 12 dB/octave
roll-off below 20–400 Hz at –3 dB point.
CH INPUT Equalization
+15,–15 dB maximum
HIGH 1k– 20 kHz (peaking, Q=0.667)
HIGH-MID 400– 8 kHz (peaking, Q=1.41/2.88)
LOW-MID 80–1.6 kHz (peaking, Q=1.41/2.88)
LOW 30– 600 Hz (peaking, Q=0.667)
ST CH INPUT Equalization
+15, –15 dB maximum
HIGH 20 kHz (peaking, Q=0.667)
HIGH-MID 3 kHz (peaking, Q=1.41/2.88)
LOW-MID 800 Hz (peaking, Q=1.41/2.88)
LOW 50 Hz (peaking, Q=0.667)
Phantom Power +48V DC is applied to balanced inputs (via 6.8 kΩ
current-limiting/isolation resistors) for power-
ing condenser microphones ; may be turned
ON or OFF via rear-panel phantom Master
switch.
When Master is ON, individual channels may
be turned ON or OFF via +48V switches(with
red LED) on each input channel.
CH LED Indicators
PEAK LED(red) built into each CH INPUT turns on
when pre-Fader level reaches +18 dB.
NOM LED(yellow) built into each CH INPUT turns
on when pre-Fader level reaches 0 dB.
SIGNAL LED(green) built into each CH INPUT turns
on when pre-Fader level reaches –10 dB.
ST CH LED Indicators
PEAK LED(red) built into each ST CH INPUT turns
on when pre-Fader [L+R] level reaches +18
dB.
NOM LED(yellow) built into each ST CH INPUT
turns on when pre-Fader [L+R] level reaches
0 dB.
SIGNAL LED(green) built into each ST CH INPUT
turns on when pre-Fader [L+R] level reaches
–10 dB.
Oscillator/Noise Switchable sine wave @ 100 Hz, 1 kHz or 10
kHz(1% T.H.D. @ +4 dB output), or pink
noise.
Scene Memory Direct Scene Memory recall switches (1–8)
Switchable Scene Memory recall (1–128)
VU Meters 12 illuminated meters
(0VU=+4 dB output @ 600 Ω load)
#1 ; MIX1 / MIX9 / MATRIX1
#2 ; MIX2 / MIX10 / MATRIX2
#3 ; MIX3 / MIX11 / MATRIX3
#4 ; MIX4 / MIX12 / MATRIX4
#5 ; MIX5 / MIX13 / MATRIX5
#6 ; MIX6 / MIX14 / MATRIX6
#7 ; MIX7 / MIX15 / MATRIX7
#8 ; MIX8 / MIX16 / MATRIX8
#9 ; STEREO A L
#10; STEREO A R
#11; STEREO B L / CUE L
#12; STEREO B R / CUR R
VU Meter Peak Indicators LED(red) built into each VU meter turns on
when output signal is above the level 3 dB
lower than clipping level.
Dimension Height 265 mm
Depth 874 mm
Width 2571 mm(56C), 2043 mm (40C),
1779 mm (32), 1515 mm(24)
Weight 128 kg (56C), 108 kg (40C), 95 kg (32),
85 kg(24)
*1 Hum & Noise are measured with a 6 dB/octave filter @ 12.7 kHz;equiv-
alent to a 20 kHz filter with infinite dB/octave attenuation.
For European Model
Purchase/User information specified in EN55103-1 and EN55103-2.
Conformed Environment: E1, E2, E3 and E4.