Filter
Top Products
Note
Pitch Bend
Note data filter. This filter should normally be turned off to
allow reception of all note data.
Turn this filter on if you do not want to record pitch bend data
received by the QY300, or you simply don’t want received pitch
bend data to affect the QY300 sound.
Cntrl Change
This filter can be used to block reception of all control
change events: modulation, breath controller, volume, sustain
pedal, etc. Control change bank select numbers (0 and 32)
are affected by the Program Change filter (below), not the
Cntrl Change filter.
Program Change
Poly After
Ch. After
Sys Ex.
The program change filter can be turned on if you want to switch
voices on an external keyboard or other controller without
switching the QY300 voices as the same time.
As mentioned aove, aftertouch generates a lot of data that can
rapidly fill the available memory if used indiscriminately. When
on, this filter blocks reception of polyphonic aftertouch data.
Similar to the polyphonic aftertouch filter, but this filter blocks
reception of monophonic (channel) aftertouch data.
Blocks reception of all system exclusive data when turned on.
Fingered Chord Zone Assignment
The QY300’s advanced ABC system can be controlled from an external key-
board, making it useful as an ABC expander module. The Fingered Chord
Zone utility function sets the range of notes in which chords played will be
recognized by the QY300 ABC system.
ABC chord changes will
be ignored during step
or realtime recording of
any track other than the chord
track, and in the edit or job
modes.
117