Filter
Top Products
The
“Gate Time”
and
“Velocity”
parameters increase or decrease the gate
times (length) and velocity of all notes affected by the swing parameter. The
range of both parameters is from 0% to 200%. The “Gate Time” parameter sets
the ratio between the shorter and longer gate time values. A setting of “100%”
maintains the original relationship between the notes, lower values produce a
narrower gate time range, and higher values produce a broader gate time range.
The “Velocity” parameter sets the ratio between the lower and higher velocity
values. A setting of “100%” maintains the original relationship between the
notes, lower values produce a narrower dynamic range, and higher values
produce a broader dynamic range.
After setting the parameters as required press [ENTER] to execute the
Quantize job. The metronome icon will appear on the display while the data is
being processed, then “Completed” will appear briefly when the job is done.
Press the
[F6]
key (“Exit”) to return to the job list, or a mode key to go directly
to the selected mode.
02: Modify Velocity
Increases or decreases the velocity values of all notes in the specified track and
range of measures.
The
“TR”
parameter selects the track to be affected by the Modify Velocity
job: “01” ... “16”.
The
“M”
parameters above the graphic bar are used to specify the first
measure:beat and last measure:beat of the range to be modified.
The
“rate”
parameter sets the ratio between the lower and higher velocity
values. A setting of “100%” maintains the original relationship between the
notes, lower values produce a narrower dynamic range, and higher values
produce a broader dynamic range. The range is from “0%” to “200%”.
The
“offset”
parameters determines the amount of velocity change. “–”
settings reduce the velocity while “+” settings increase the velocity. The range
is from “-99” through “0” to “+99”.
37