Filter
Top Products
Save & Load
The save and load operations via the DISK mode are the same as the direct
save and load operations described above.
The disk write-protect
slide must
be in the
write-enable position to
perform a save operation. If it is
not, the “Write Protected!” error
message will appear when you
attempt to execute the save op-
eration.
• File names can be up
to 8 characters in
length. Lower-case
characters will be converted to
capitals when saved.
• The last-entered file name is
automatically shown by de-
fault.
• If you use characters not rec-
ognized by the MS-DOS oper-
ating system, the file name
may not be recognized if you
attempt to read the disk on
different equipment.
For a save operation specify the data to be saved (not required if saving “1 All
Data”), enter a file name if necessary, and press
[ENTER].
If a file having the
specified file name already exists on the current disk, the “Delete Old Data?’
display will appear. Respond to this display with the [+1/YES] key to go
ahead with the operation or the
[-1/NO]
key to cancel.
An “Executing
!” bar graph will appear to show the progress of the save
operation. “Completed” will appear briefly when the operation has finished.
For a load operation select the file to be loaded, the destination (song, style, or
phrase number — not required if loading “1 All Data”) and press
[ENTER].
If
previous data exists in the specified destination the “Delete Old Data?” display
will appear.
Respond to this display with the
[+1/YES]
key to go ahead with the operation
or the
[-1/NO]
key to cancel.
An “Executing
!” bar graph will appear to show the progress of the load
operation. “Completed” will appear briefly when the operation has finished.
123