Filter
Top Products
Error Messages
Monitor
Illegal Input
Improper data was input.
Preset Phrase
Attempted to change data defining a preset phrase.
No Data
There is no data. The job could not be executed.
MIDI
MIDI Data Error
Received improper MIDI data; the cable may be bad.
Checksum Error
Error receiving bulk data (incorrect checksum).
Buffer Full
MIDI Receive Buffer was full. All buffer contents cleared.
Now Running
Cannot receive bulk data while sequence is playing.
Data Exists
Cannot receive bulk data for song that already has data.
Bulk Ignored
Bulk data was received when the system was not in top of song mode.
Only l-song data for the QY10, 20 is acceptable. The received bulk data was not
the correct type.
DISK
No Disk
No disk in drive.
Illegal Format
Disk is not in MS-DOS format.
Bad Disk
Disk is damaged; cannot read data.
File Not Found
Unable to find the specified file.
Write Protected
Cannot write to disk: the disk’s write-protect tab is on.
Disk Full
Cannot write more data to disk: the disk’s data capacity (712K) or directory capac-
ity (112) is full.
Illegal File
Attempted to read file type not supported by QY300. (QY300 supports SMF and
ESEQ only.)
Can’t Change File Name
Attempted to change existing filename.
System
Memory Full
The sequencer’s memory is full. The sequencer cannot record more data; jobs
cannot execute.
Battery Low
The memory-backup battery is low; memory cannot be backed up.
etc.
Now Working
Restoring internal data. (This message may appear following Power On, immedi-
ately after the Greeting.)
Delete Old Data? (Yes/No)
Specified song or file already exists; load/save operation will delete existing data.
Can’t Undo. OK? (Yes/No)
Memory is too full to support Undo; execution will be irreversible.
127