Filter
Top Products
02: Append Pattern
Appends the specified section of one style to the end of the specified section of
a second style.
• If the length of the
destination plus
appended pattern ex-
ceeds 8 measures (the maximum
pattern length), the “Illegal In--
put” error message will appear
and the append operation will
be aborted.
• This job does not copy voice
or play effect data from the
source style.
The upper “Style” parameter selects the source style — i.e. the style from
which the data is to be copied: “001” ... “100”.
The upper
“Section”
parameter selects the source section — i.e. the sec-
tion of the source style from which the data is to be copied: “Intro”, “MainA”,
“MainB”, “FillAA”, “FillBB”, “FillAB”, “FillBA”, “Ending”.
The lower
“Style”
parameter selects the destination style — i.e. the style
to which the data is to be appended: “001” ... “100”.
The lower “Section” parameter selects the destination style — i.e. the
section of the destination style to which the data is to be appended: “Intro”,
“MianA,, “MainB”, “Ending” Fills cannot be selected as the destination sec-
tion since they can be only one measure in length.
After setting the parameters as required press
[ENTER]
to execute the Append
Style job. The metronome icon will appear on the display while the data is
being processed, then “Completed” will appear briefly when the job is done.
Press the
[F6]
key (“Exit”) to return to the job list, or a mode key to go directly
to the selected mode.
03: Split Pattern
Splits a specified section of a specified style into two parts at the specified
measure, and moves the latter half to the specified section of a specified style.
88