Filter
Top Products
QY300 realtime recording
is “replace” recording,
meaning that any previous
data in the a track will be erased
and replaced when new data is re-
corded to that track. This is in con-
trast to “overdub” recording in
which new data is recorded over the
existing data and the existing data
remains intact. In the QY300 step
recording, described later, allows
new material to be added to a track
without erasing the previous data.
You can also use the “Mix Track”
job (page 50) to mix data from two
tracks and place the result on a sin-
gle track.
See the “Editing Songs &
Phrases” section, page
104, for information on
how to edit recorded song data.
Record
Press the
key to begin recording. The metronome will sound and you’ll be
given a two-measure count-in prior to the first measure actually recorded. The
count-in is also indicated by negative numbers in the “Meas” parameter. If a
4/4 time signature is selected, for example, the count-in will run from measure
“-08” to “-01”, then recording will begin from measure “001”.
The “Click” parameter determines whether the metronome sounds during recording,
playback and recording, or at all times.
The metronome can also be turned off. See “Click (Metronome) Settings” on page 26.
Play the required part either on the micro-keyboard or via an external MIDI
keyboard.
Stop Recording
Press the
key to stop recording. The normal SONG play mode is automati-
cally re-selected when you stop recording, and you’ll automatically be re-
turned to the top (first measure) of the song.
Record Other Tracks As Required
Repeat steps 2 through 8 to record other sequencer tracks, as required.
25