Filter
Top Products
16
About SmartMedia
Operating the Unit on Batteries
About SmartMedia / Operating the Unit on Batteries
SmartMedia contents
Besides the demo song play data and audio data, the SmartMedia card
supplied with the PS-02 contains the system data necessary for operation
of the PS-02. Note that the PS-02 will only start up when a suitable
SmartMedia card is inserted in the [DATA CARD] slot.
SmartMedia work card
When recording with the PS-02, all audio data is stored on SmartMedia.
In the condition as shipped from the factory, the supplied SmartMedia
card has a certain amount of free space, but for longer recordings, you
will need to erase demo songs or use another SmartMedia card (32MB or
higher is recommended).
If the system program contained on the original supplied SmartMedia
card is accidentally damaged or erased, the PS-02 will not be able to
operate normally. It is therefore strongly recommended to format a new
SmartMedia card to create a working card. After doing this, store the
original supplied SmartMedia card in a safe place.
For information on how to erase a song, see page 43.
For information on how to format a working SmartMedia card, see page 75.
Four IEC R03 (size AAA)
batteries
Battery
compartment cover
2. Turn the PS-02 over and open the cover
of the battery compartment.
Push the tab down and then slide the
cover in the direction.
3. Insert four IEC R03 (size AAA) batteries (the
use of alkaline batteries is recommended)
into the compartment, taking care to
establish correct +/- orientation.
4. Slide the battery compartment cover in the opposite direction
to close it.
When the batteries are getting low, the battery indication ( ) appears on the display.
When not using the PS-02, do not forget to turn the unit off to preserve battery power.
1. Verify that power to the unit is turned off.