Filter
Top Products
Operation Guide
23
After the pattern has been input, you should program chord change
information following the diagram on page 18. Unlike pattern change
information, chord change information can be specified in beat units.
◆
Entering chord change information
1.At the pattern input display, press the cursor [ ] key (or
[ ] key).
The display switches to the chord change information input mode.
While programming the rhythm track, each push of the cursor [ ] ([ ]) key
toggles between the pattern input display and chord input display.
2.Use the cursor [ ]/[ ] keys to move to measure 1.
In the initial condition, only the chord change information "Am" (A
Minor) is entered in measure 1.
3.Use sliders 1/2 to specify the chord for measure 1 ("D" in
this example).
In chord input mode, slider 1 specifies the root and slider 2 the type
of the chord (Major, Minor, etc.).
Program chord change information
PATTERN CHORD
RECORD MIXDOWN