Filter
Top Products
64
Because the EQ module has many parameters, the display consists of two
screens. When switching between these two screens, the flashing dot
position does not change.
4.To switch the effect type of the currently selected module,
use the cursor [ ]/[ ] keys.
The DRIVE, MOD, and REV modules comprise several effect types,
of which you can select one. (When you select a different effect type,
the usable effect parameters change accordingly.) For a listing of
modules, selectable effect types, and parameters, see page 79 - 83.
The cursor [ ]/[ ] keys have no effect on modules which are currently Off
or modules for which there is only one effect type.
5.To change the parameter of the currently selected module,
operate sliders 1 - 3.
In the Effect Edit menu, sliders 1 - 3 serve to edit the effect
parameters of the currently selected module.
When a slider is moved, the corresponding parameter name and
setting value are shown on the display.
You can also check the setting of the current parameter without moving the
slider. To do this, press the [EDIT] key while in the Effect Edit menu. Each
push of the key causes the display to cycle through parameter 1
➝
parameter 2 ➝ parameter 3 ➝ effect type.
6.To toggle the currently selected module between On and
Off, press the [BYPASS TUNER] key.
When the effect module is set to Off, the indication "-OFF-" appears
on the display.
7.To set the final patch level, use the cursor [ ]/[ ] keys to
select "P-LVL" of the TOTAL module, and then use slider 1
to make the adjustment (setting value 1 - 30).
Parameter setting
Effect parameter name
Reference Guide