Filter
Top Products
Other Functions
ZOOM RT-223
71
to the appendix at the end of this manual.
Checking the remaining
memory capacity
To display the remaining amount of free memory,
proceed as follows.
1.
Press the [FUNCTION] key followed
by the [PATTERN] key.
The remaining amount of free memory is
displayed (in percent). This display is for
information only, it cannot be changed.
HINT
To increase the amount of free memory,
delete patterns and songs that are no
longer required.
2.
To return to the previous mode,
press the [FUNCTION] key or the
[EXIT] key.
Turning the backlight off
You can use the RT-223 with the display
backlight turned off.
Turn power to the RT-223 on while holding down
the VALUE [-] key. The backlight will be turned
off, and the unit consumes less power. This is
convenient when remaining battery capacity is
low.
Returning the RT-223 to
the factory default
condition (initialization)
You can return all data in the RT-223 to the
factory default condition.
NOTE
Use this function with care, because it will
erase all patterns and songs that have
been recorded by the user. These cannot
be restored.
1.
Turn power to the RT-223 on while
holding down the REC [
O
] key.
The indication “ALLINIT” flashes on the display.
2.
To go ahead with the initialization,
press the REC [
O
] key once more.
To cancel the procedure, press the
[EXIT] key.
When initialization is carried out, all settings and
data of the RT-223 are reset to the factory default
condition, and then the unit starts up.
If the process was canceled, the RT-223 starts up
normally.
HINT
If required, you can restore selected
patterns (
→
p. 32) , drum kits (
→
p. 52) or
effect patches (
→
p. 58) to the factory
default condition.