3Com 3500 Manual

A SERVICE OF

next previous

bridge trunk define

311

5

Enter the trunk name, or to get information about specifying the trunk

name, enter

?

6

Specify whether TCMP is enabled or disabled.

The system indicates that the trunk definition is complete and allows you

to define additional trunks until you reach the system trunk limit.

7

At the system prompt, to define another trunk enter

y

(yes) or to end the

trunk sequence, enter

n

(no).

You must then reboot to enable the trunks to take effect.

Bridge Trunk Define Example (9000)

The example shows a define operation that creates two trunks.

Select menu option: bridge trunk define

Select mac type {Fast_Ethernet,Gigabit_Ethernet|?}: Fast_Ethernet

Select ports (14-19|all|?): 14-18

Enter mode {100half,100full|?}: 100full

Enter trunk name {?} []: “Trunk_1”

Enter TCMP state (disabled,enabled) [enabled]: enabled

Trunk definition complete

Define another trunk? (y,n) [n]: y

Select mac type {Fast_Ethernet,Gigabit_Ethernet|?}: Fast_Ethernet

Select up to 8 ports (1-12|?): 1-6

Enter trunk name {?} []: Trunk2

Enter TCMP state (disabled,enabled) [enabled]:enabled

Trunk definition complete

The configuration of the ports will be modified.

The system must be rebooted to complete trunk configuration.

This may take a few minutes.

Are you sure you want to reboot the system? (n,y) [y]: y