Filter
Top Products
ARTURIA – JUPITER-8V – USER’S MANUAL
104
• An ADSR envelope connected to the amplifier
• The Galaxy module
• The Arpeggiator
• Voice effect » Chorus / Flanger »
• Patch effect » St Reverb »
• Patch effect » St Delay »
Increase the release time for the second ADSR envelope (for example to the range
of 8000 ms) in order to give the impression of a harp tone.
Increase the release time for the second ADSR envelope
Increase the cut off frequency of the high pass filter (to the range of 800 Hz)
Lower the resonance rate of the VCF almost to the minimum.
Activate the arpeggiator by clicking on the buttons «Range 2» and «Mode UDN».
Then play a chord on your MIDI keyboard. An arpeggio will be heard.
Setting of the arpeggiator
If you work with a MIDI Sequencer and you wish to synchronize the arpegiator to the tempo of the
sequencer, click on the switch «INT / EXT» situated next to the «Rate» fader of the arppegiator then place it
toward the bottom into the position «EXT»
Click on the selector «Hold Up» if you wish to hold the arpeggio in play mode.
Click on the « Hold Up » selector