Filter
Top Products
ARTURIA – JUPITER-8V – USER’S MANUAL
105
We will use the Galaxy unit to modulate the width of the square wave form of the second
VCO, the cut off frequency of the high pass filter and the low pass filter (VCF)
Open the «Modulations» page situated in the upper panel of the Jupiter-8V. the
Galaxy unit is selected by default.
Open the «Modulations» page
Choose the destination parameters of the modulations for LFO1 (Y output) and 2 (X
output):
LFO1 HPF Cutoff
LFO2 VCF Cutoff
Set the depth of these modulations with the knobs situated next to these
destinations. (Take values around “0.900» for the HPF «Cutoff» and «0.500» for the
«VCF Cutoff»)
Settings of the galaxy unit
If you wish to give space to your sound, add chorus, reverb or delay effects. To do that,
click on «Effects» situated in the upper panel of the Jupiter-8V.
In the first «Voice» effect slot (at the top of the connection diagram for the effects),
choose «Chorus / Flanger». This will be placed between the VCO and the filters.
Set the speed of the chorus frequency with the («Rate») knob to your convenience
You also can adjust the numbers of repetitions («feedback») to your convenience.
Set the «dry/wet» knob of the chorus in a manner to balance between the original
and the effected sound.