Filter
Top Products
ARTURIA – JUPITER-8V – USER’S MANUAL
33
4.5.1 Creating a melodic sequence with the SEQUENCER
The sequencer is accessible by clicking on the “MODULATIONS” tab, situated on the
expansion panel. Click on the “SEQUENCER” icon.
The sequencer is a 32-step “step sequencer”. It allows the creation of several melodic
lines (when one of the three available modulations is affecting the frequencies of the
VCO) as well as creation of dynamic modulations of other parameters such as the cut-off
frequency of the VCF or on the width of the square waveform of the VCO's.
It enables you to affect up to 3 simultaneous parameters.
The step sequencer
In this chapter we will see how to create a simple melodic sequence.
Click on the “MODULATIONS” tab, and then click on the “SEQUENCER” tab to bring
up the interface.
Click on the “SEQUENCER” button
Connect the frequency of VCO1 to the first modulation output and click the “Q”
button to activate the quantize factor by half-tones for the frequency values.
Set Sequencer Output 1