Filter
Top Products
ARTURIA – JUPITER-8V – USER’S MANUAL
79
The connection section
7.3 G
ALAXY
The galaxy module creates very complex modulations with the interaction of 3 LFOs.
The first 2 LFOs can each modulate a different parameter on the X/Y axes, represented in
the framework of the interface. A third LFO allows modifying the alpha angle between the
X and Y axes.
Each of these 3 LFOs have two parameters:
SHAPE
Selection screen for the waveform of the LFO and X/Y axis (“Sine”, “Tri”,
“Saw” and “Square”) and “Sine”, “Tri” and “Saw” for the third LFO.
RATE
Knob to set the modulation frequency of the LFO.
ANGLE
Knob to set the rotation angle of the X/Y axis manually.
Three modulation outputs can be connected. For each, the following modulation
destinations are available:
• “None”: Nothing is connected
• “VCO1 Pitch” VCO1 FREQUENCY
• “VCO2 Pitch”: VCO2 FREQUENCY
• “VCO1 PW”: Pulse width of the square wave form of VCO1
• “VCO2 PW”: Pulse width of the square wave form of VCO2
• “HPF Cutoff”: Frequency of the high pass filter
• “VCF Cutoff”: Frequency of the low pass filter
• “VCF Res”: Resonance of the low pass filter
• “VCA”: Volume of the VCA
A reset setting of the movements for the three LFO's by a played note is available by
using the “RETRIG” button.