Filter
Top Products
ARTURIA – JUPITER-8V – USER’S MANUAL
39
In order to enrich the sound, the effect “Distortion” has been inserted between the
VCO and VCF (Filter). Change this effect to “No Effect” and back to “Distortion” to
observe the differences of sound.
Choose the effect of “Distortion” in the effects menu.
The interface of the distortion effect is now on screen.
Adjust the distortion amount with to the “Drive” knob and see the changes in the
sounds as well as in the curve.
Change modulation source and amount.
Adjust the mix of Dry/Wet signals.
The “Distortion” effect
Place a second effect between the VCF and the VCA. Take the “Param EQ”. Certain
parameters of this effect will be modulated by the LFO in order to create an effect similar
to phasing. The Param EQ is composed of 4 filters: Band 1 is a low shelving filter, Band 2
and 3 are middle peaking filters and Band 4 is a high shelving filter. They can be
activated or deactivate by clicking on the “Band 1/2/3/4” buttons.
• Adjust the volume of the frequency of “band 3” with the knob “G” (GAIN) or simply
modify the point in the gain curve
Set the volume of the frequency for « band 3 »