Filter
Top Products
ARTURIA – JUPITER-8V – USER’S MANUAL
76
7.2 S
TEP
S
EQUENCER
The sequencer is a 32-step sequencer.
It allows the creation of several melodic lines (when one of the three available
modulations is affecting the pitch of the VCO) as well as creation of dynamic modulations
of other parameters such as the cutoff frequency of the VCF or the width of the VCO
square waveform.
Click on the “Modulations” tab, then, click on the “Sequencer” button to bring up the
interface.
The step sequencer
The interface of the sequencer consists of three main parts:
7.2.1 The transport
The transport is on the left side of the sequencer. It consists of the necessary parameters
to play and stop the sequence, MIDI synchronization, quantification and trigger (“trigg”)
parameters:
START
STOP
Selection screen to control the sequencer’s playing mode:
• Note On/ Note OFF: Start / Stop with a note ON / OFF message.
• MIDI Start / Stop : Start / Stop the sequencer with a MIDI sequencer
(or a drum machine for instance)
• Free running: Start / Stop the sequencer with the Start/Stop buttons
of the step sequencer.
START
STOP
buttons
Start / Stop the sequencer, in “free running” mode only
RATE
Set the speed of the sequencer, in “free running” mode only
SYNC
ON/OFF
Synchronization to an external MIDI clock
Q
Subdivision of MIDI tempo to adjust the speed of the sequencer in “MIDI
Sync” mode:
1/2 ;1/4 ;1/4T ;1/8 ;1/8T ;1/16 ;1/16T ;1/32 ;1/32T ;1/64 ;1/128