Filter
Top Products
English
Using the Assignable Buttons
E-25
While the
(ASSIGNABLE 2) button is on, only the
sound of a specified zone is output without passing
through the DSP.
Common Parameter Information:
NOTE
• For more information about DSP bypass, see the
flowchart under “Master Control Configuration”
(page E-4).
Since control change is a MIDI message, the target of a
send operation generally is an external MIDI device.
*
With the
(ASSIGNABLE 1) button, different control
change values can be specified for sending at the points
the button is pressed and when it is released.
With the
(ASSIGNABLE 2) button, different control
change values can be specified for sending at the points
the button is turned on and when it is turned off.
Common Parameter Information:
* You also can configure control change send for the
internal sound source that corresponds to a
particular zone. See the note under “4-B, 4-C, 4-D,
5-B, 5-C, 5-D Settings when Asgn1/Asgn2 = Control
Change Number 0 to 127” (page E-23).
By-passing the DSP
(ASSIGNABLE 2)
5-A Assignable Button 2 Type (Asgn2) (page E-22)
5-B Settings when Asgn2 = DSP Bypass (Dbp) (page
E-23)
Sending Control Changes
(ASSIGNABLE 1/2)
4-A Assignable Button 1 Type (Asgn1) (page E-22)
5-A Assignable Button 2 Type (Asgn2) (page E-22)
4-B, 4-C, 4-D, 5-B, 5-C, 5-D Settings when Asgn1/
Asgn2 = Control Change Number 0 to 127 (page
E-23)