Filter
Top Products
E-32
Editing Zone Parameters
This item is for adjusting the depth
(strength) of vibrato applied to notes. A
larger negative absolute value makes vibrato
shallower, while a larger positive value makes it
deeper.
–64 to 0
*
to +63
This item is for adjusting the time until
vibrato starts to be applied to a note. A
larger negative absolute value makes the time it takes
before vibrato is applied after a note is played shorter,
while a larger positive value makes it longer.
–64 to 0
*
to +63
This item is for selecting the waveform when
applying vibrato to notes. You can select
from among the following waveforms.
* “Org” is the initial default setting for all tones. The
actual default waveform type depends on the tone.
Effect Settings
For details on the meanings of the settings in this
section, see the flowchart under “Master Control
Configuration” (page E-4).
Specifies how much of the signal from
the sound source is sent to reverb.
0 to 127 (
*
default setting depends on the tone)
Specifies how much of the signal from
the sound source is sent to chorus.
0 to 127 (
*
default setting depends on the tone)
Specifies how much of the signal from the
sound source is sent to acoustic resonance.
0 to 127 (
*
default setting depends on the tone)
Switches DSP for each zone on or off.
Selecting OFF disables DSP for that particular
zone.
OFF, ON
*
The DSP of this Digital Piano can be used
simultaneously for up to two parts. Each part (“Sound
Source Configuration”, page E-5) has a DSP priority,
which determines which of the two parts that have
DSP turned on should have the DSP effect applied. The
following shows the priorities assigned to each part.
To apply a DSP to one or two lower priority parts
(Lower2, for example), turn off DSP ON/OFF for the
higher priority parts (Upper1, Lower1, Upper2).
■ 6-B Vibrato Depth (VbDpt)
■ 6-C Vibrato Delay (VbDly)
■ 6-D Vibrato Waveform (WvFrm)
Original (Org
*
) –– Saw Down (SDw)
Sine (Sin) Pulse 1:3 (P13)
Triangle (Tri) Pulse 2:2 (P22)
Saw Up (SUp) Pulse 3:1 (P31)
INT / EXT
INT / EXT
INT
■ 7-A Reverb Send (RvbSd)
■ 7-B Chorus Send (ChoSd)
■ 7-C Acoustic Resonance Send (AReso)
■ 7-D DSP ON/OFF (DSP)
Priority Part Number Part Name
1 Part 1 Upper1
2 Part 3 Lower1
3 Part 2 Upper2
4 Part 4 Lower2
5 Part 17 to 48
Song01 to Song16,
Ext01 to Ext16
INT / EXT
INT / EXT
INT
INT