Filter
Top Products
Appendices ~ Appendix F: Serial Commands
54
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
PCMD
This command programs or returns the program of the GPIO
control pins from the serial port. COMMAND can be any valid
command. These values are not part of the preset and do not
change when presets are loaded.
[DEVICE] PCMD <LOCATION> <COMMAND>
Explanation
<LOCATION>
LOCATION=1 Control A pin 1 active
LOCATION=2 Control A pin 1 inactive
LOCATION=3 Control A pin 3 active
LOCATION=4 Control A pin 3 inactive
LOCATION=5 Control A pin 5 active
LOCATION=6 Control A pin 5 inactive
LOCATION=7 Control A pin 7 active
LOCATION=8 Control A pin 7 inactive
LOCATION=9 Control A pin 9 active
LOCATION=10 Control A pin 9 inactive
LOCATION=11 Control A pin 11 active
LOCATION=12 Control A pin 11 inactive
LOCATION=13 Control A pin 13 active
LOCATION=14 Control A pin 13 inactive
LOCATION=15 Control A pin 15 active
LOCATION=16 Control A pin 15 inactive
LOCATION=17 Control B pin 1 active
LOCATION=18 Control B pin 1 inactive
LOCATION=19 Control B pin 3 active
LOCATION=20 Control B pin 3 inactive
LOCATION=21 Control B pin 5 active
LOCATION=22 Control B pin 5 inactive
LOCATION=23 Control B pin 7 active
LOCATION=24 Control B pin 7 inactive
LOCATION=25 Control B pin 9 active
LOCATION=26 Control B pin 9 inactive
LOCATION=27 Control B pin 11 active
LOCATION=28 Control B pin 11 inactive
LOCATION=29 Control B pin 13 active
LOCATION=30 Control B pin 13 inactive
LOCATION=31 Control B pin 15 active
LOCATION=32 Control B pin 15 inactive
<COMMAND>
COMMAND=String Pin will execute string when
actuated
COMMAND=Null Parameter to return the current
programming for the pin
COMMAND=Clear Parameter to clear current
programming (do nothing state)
COMMAND LIST: LFP, PRESET, MUTE, GAIN, AGC,
EQ, GMODE, CHAIRO
Return Values
The command will return the updated condition of the pin in
the same format as the command. If the command did not
alter the state, the command returns the current command
for which the pin is programmed.
Example
The PCMD command line contains both the PCMD command
and the command being programmed. To program AP800
unit 0 control A pin 1 to toggle mute on mic 1, the command
would appear as follows: #10 PCMD 1 MUTE 1 I 2 (toggles
mute to the opposite state: ON to OFF and vice versa)