Filter
Top Products
5 - 79
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid
(
: Valid, : Invalid)
MR-J3-B
Value set with PLC program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0 to 3000 70 30147 30347 30547 30747
1 to 2000 37 30148 30348 30548 30748
20 to 50000 823 30149 30349 30549 30749
1 to 50000 337 30150 30350 30550 30750
1 to 1000 1000 30151 30351 30551 30751
1 to 1000 1000 30152 30352 30552 30752
2: The PB
corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.