Filter
Top Products
7 - 19
MELSEC-Q
7 MEMORY CONFIGURATION AND DATA PROCESS
(b) When the servo parameter "
Pr.100
Servo series"="0" is stored flash ROM.
Communication start timing to the servo amplifier: The data written from
PLC program before the
PLC READY signal [Y0]
ON (Fig. 7.1 B).
Transfer the servo parameter : The data written from
PLC program before the
PLC READY signal [Y0]
ON (Fig. 7.1 C).
(2) Servo parameter transfers when servo amplifier had started after the PLC
READY signal [Y0] is turned OFF to ON (Fig. 7.1 B)
Communication start timing to the servo amplifier: when servo amplifier had
started
Transfer the servo parameter : The data written from
PLC program before the
PLC READY signal [Y0]
ON (Fig. 7.1 C).