Filter
Top Products
Switching the power on and off
V-Accordion
r
15
Switching the power on and off
The power-on procedure depends on whether you are
using a battery or the FBC-7 Foot Pedal/DC Power/ Bat-
tery Charger Unit.
Note: Only use the battery that either came with your FR-7 or
that you purchased from your Roland dealer. Using other batter-
ies can severely damage the FR-7/FR-5 or FBC-7. Roland assumes
no responsibility for damages caused by batteries that have not
been explicitly approved. Such damages are not covered by
Roland’s warranty regulations.
If you are using a battery and no external
amplification (FR-7 only)
(1) Press the FR-7’s [POWER] button (it lights) to
switch it on.
Note: You can also connect headphones.
(2) Start playing (see “First steps” on page 17).
(3) Press the [POWER] button again so that it goes
dark when you are finished.
If you are using a battery and an audio connec-
tion to an external device
The FR-5 needs to be connected to an amplification
system of some sort (unless you want to use head-
phones), while you also need the FBC-7.
Note: You can also purchase a wireless transmitter from your
Roland dealer and connect it to the OUTPUT sockets on the
FR-7/FR-5.
(1) Turn down the output volume of the receiving
audio device.
You can also simply switch it off.
(2) Connect the FR-7/FR-5’s OUTPUT sockets to the
external audio device using two 1/4” guitar cables.
Note: You can also connect headphones to the PHONES
socket, in which case you do not need to establish an audio
connection.
(3) Press the FR-7/FR-5’s [POWER] button (it lights) to
switch it on.
The icon informs you that the FR-7/FR-5 runs on
the battery (it also indicates the battery’s status).
(4) Switch on the receiving audio device.
(5) Start playing (see “First steps” on page 17).
—To switch off your system—
(6) Turn down the output volume of the receiving
audio device or switch it off.
(7) Press the FR-7/FR-5’s [POWER] button again so
that it goes dark.
If you are using the FBC-7
If the FR-7/FR-5 is powered by the supplied FBC-7
unit, proceed as follows:
(1) Connect the FR-7/FR-5 to the FBC-7 using the
supplied 19-pin cable.
(2) Connect the FBC-7’s AC INLET socket to a wall out-
let that meets the specifications (see p. 81).
The FBC-7 should only be connected to a power
source of the type marked on the bottom of the unit.
For details on the power consumption, please refer to
page 81.
(3) Turn down the output volume of the receiving
audio device.
You can also simply switch it off.
(4) Connect the FBC-7’s OUTPUT sockets to the exter-
nal audio device (amplifier, mixing console, etc.).
Though you can also use the FR-7/FR-5’s OUTPUT
sockets, doing so is probably only a good idea if you
are working with a wireless transmitter. Using the
FBC-7’s OUTPUT sockets indeed means that you only
need one connection between the FR-7/FR-5 and the
FBC-7.
(5) Press the FBC-7’s [POWER¥ON] button to switch it
on.
The POWER ON indicator on the FBC-7’s top panel
lights red.
To a wall outlet