Roland FR-7/FR-5 Musical Instrument User Manual


 
Important notes
V-Accordion
r
9
In addition to the items listed under “Using the unit safely” on p. 7, please read and observe the following:
Power supply
Do not use this instrument on the same power circuit with any
device that will generate line noise (such as an electric motor or
variable lighting system).
Before connecting the FR-7/FR-5 to other devices, turn off the
power to all units. This will help prevent malfunctions and/or dam-
age to speakers or other devices.
Although the LCD and LEDs are dark when the POWER switch is
off, this does not mean that the unit has been completely discon-
nected from the power source. To turn off the power completely,
first turn off the POWER switch, then unplug the power cord from
the wall outlet. For this reason, the outlet to which you connect
the power cord’s plug should be one that is within easy reach.
Placement
Using the FR-7/FR-5 near power amplifiers (or other equipment
containing large power transformers) may induce hum. To allevi-
ate the problem, change the orientation of this unit; or move it
farther away from the source of interference.
This device may interfere with radio and television reception. Do
not use this device in the vicinity of such receivers.
Do not place the FR-7/FR-5 near devices that produce a strong
magnetic field (e.g., loudspeakers).
Install the FR-7/FR-5 on a solid, level surface.
Noise may be produced if wireless communications devices, such
as cell phones, are operated in the vicinity of this unit. Such noise
could occur when receiving or initiating a call or while conversing.
Should you experience such problems, relocate such wireless
devices so they are at a greater distance from this unit or switch
them off.
Do not expose the unit to direct sunlight, place it near devices that
radiate heat, leave it inside an enclosed vehicle or otherwise sub-
ject it to temperature extremes. Also, do not allow lighting devices
that normally are used while their light source is very close to the
unit (such as a piano light) or powerful spotlights to shine upon
the same area of the unit for extended periods of time. Excessive
heat can deform or discolor the unit.
To avoid possible breakdown, do not use the unit in a wet area,
such as an area exposed to rain or other moisture.
Do not allow rubber, vinyl or similar materials to remain on the
instrument for long periods of time. Such objects can discolor or
otherwise harmfully affect the finish.
Do not put anything that contains water (e.g., flower vases) on the
instrument. Also, avoid the use of insecticides, perfumes, alcohol,
nail polish, spray cans, etc., near the unit. Swiftly wipe away any
liquid that spills on the unit using a dry, soft cloth.
Do not allow objects to remain on top of the keyboard or buttons.
This can be the cause of malfunction, such as keys or buttons ceas-
ing to produce sound.
Do not paste stickers, decals or the like on this instrument. Peeling
these off, particularly when strong adhesives have been used, can
damage the instrument’s exterior finish (the stickers provided with
this instrument feature a weak adhesive).
Maintenance
For everyday cleaning wipe the FR-7/FR-5 with a soft, dry cloth or
one that has been slightly dampened with water. To remove stub-
born dirt, use a mild, non-abrasive detergent. Afterwards, be sure
to wipe the instrument thoroughly with a soft, dry cloth.
Never use benzene, thinner, alcohol or solvents of any kind, to
avoid the possibility of discoloration and/or deformation.
Repairs and data
Please be aware that all data contained in the instrument’s mem-
ory may be lost when it is sent for repairs. In certain cases (such as
when circuitry related to memory itself is out of order), we regret
that it may not be possible to restore the data. Roland assumes no
liability concerning such loss of data.
Additional precautions
Please be aware that the memory contents can be irretrievably lost
as a result of a malfunction or the improper operation of the
instrument. Therefore, be sure to archive important settings using
the FR-7/FR-5’s Bulk Dump function (see p. 75).
Use a reasonable amount of care when using the instrument’s but-
tons, other controls and jacks/connectors. Rough handling can
lead to malfunctions.
Never strike or apply strong pressure to the display.
When connecting/disconnecting cables, grasp the connector
itself—never pull on the cable. This way you will avoid causing
shorts or damage to the cable’s internal elements.
A small amount of heat will radiate from the instrument during
normal operation. This is perfectly normal.
To avoid disturbing your neighbors, try to keep the instrument’s
volume at reasonable levels. You may prefer to use headphones, so
you do not need to be concerned about those around you (espe-
cially late at night).
When you need to transport the instrument, package it in the box
(including padding) that it came in. Otherwise, you will need to use
equivalent packaging materials or a flightcase.
Use only the specified expression pedal (EV-5, EV-8; sold sepa-
rately). By connecting any other expression pedals, you risk caus-
ing malfunction and/or damage to the FR-7/FR-5.
Use a cable from Roland to make the connection. If using some
other make of connection cable, please note the following precau-
tions.
Some connection cables contain resistors. Do not use cables that
incorporate resistors for connecting to this unit. The use of such
cables can cause the sound level to be extremely low or impossible
to hear. For information on cable specifications, contact the man-
ufacturer of the cable.
Precautions for the included (FR-7) or optional
(FR-5) battery
The temperature range for use of the batteries is as follows. Using
them outside this range may impair battery performance and
shorten battery service life.
Use (discharging)
: 0~50°C,
Storage
:
–20~30°C,
Charging
: 0~40°C.
Do not use or store a battery at high temperature, such as in
strong direct sunlight, in cars during hot weather or directly in
front of heaters. This may cause battery fluid leakage, impaired
performance and shorten the battery’s service life.
Do not charge a battery while it is cold (below 0°C) or outside
when it is freezing. This may cause battery fluid leakage, impaired
performance and shorten the battery’s service life.
Do not splash fresh or saltwater on a battery or allow the termi-
nals to become damp. This may cause heat generation and forma-
tion of rust on the battery and its terminals.
Use only the supplied FBC-7 to charge the FR-7/FR-5’s battery.
Failure to follow proper charging procedures may cause excessive
current flow, loss of control during charging, leakage of battery
fluid, heat generation, bursting or fire.
For the procedure for charging the FR-7/FR-5’s battery, please
read page 32.
2. Important notes